Hi. I have a unique issue with a client. They want for normal days
(First part)1 ISP that is used for upload only (Wan1) 1 ISP that is used
for download only (Wan2) Best method to set this up? Then, on streaming
days they want to switch it to (second...
Hi. I have a 90D and 2 x 221C WAPs. I put this in " local bridge" so
that the wired and wireless could be on the same subnet. Ever since I
did this the wireless to a certain IP (outside) is slow. Wired is not
slow at all. All UTM is disabled currentl...
Hi. One of our 80Cs failed, and we were given an 80CM as a replacement.
I tried to restore our config from the backup but it says it is not
compatible. They both have the exact same build on them. Does anyone
know the changes I would need to make in ...
Hi all. I believe I am making this harder than it is, but here goes. Wan
1 - Bonded dual T1s (for servers, and failover internet) Wan 2 - 50x5
cable Lan - 10.9.29.0/24, server are 10.9.29.11-18 2 point to points,
with cisco routers that are inside, h...
Hi. What is the best way to force int1 to use wan1, and int2 to use
wan2? Can provide more details if needed. (I use to use this with vdoms,
but just setup foritAPs up and didn' t want to go through Inter-VDOM
issues). Thanks
hmm, I see where you are going. All users, but I believe they upload
strictly through Box over HTTPS. They are a media production company, so
they have very large files.
Yes, my guess is I would have to change the the weight to 100 and 0 for
the other devices so they essentially use WAN2 only. We shall see what
the client thinks. Before they had WAN2 I had traffic shaping for the
streaming devices for guaranteed band...
Understood. I couldn't figure out a way to say if it was upload or
download from the client side, and wanted to make sure I wasn't missing
anything. They are simply doing two wan interfaces that are NATed. NO
BGP. I think just enabling SD-WAN for the...