Show Full-Configuration command without more

[dacrusher1]

Hi Everyone, I see that when I run the show full-configuration command on my 600C, v4.0 MR3 Patch 7 , it pauses and I have to hit a key to get more info. Is there a way to remove this so that it returns everything? When I run the same command on my 80C, v 4.0 MR3 Patch 5, it returns everything at one time. Thanks in advance!!

[dacrusher1]

Sorry for the simple question. I found the answer after further investigation... Just set output to standard.

[ede_pfau]

from the CLI:

 config system console
     set output standard
 end