Hot!Failover Internet to Teltonika RUT240 4G

Author
RedRhombus
New Member
  • Total Posts : 4
  • Scores: 0
  • Reward points: 0
  • Joined: 2018/01/09 14:46:46
  • Status: offline
2021/09/27 12:53:07 (permalink) 6.0
0

Failover Internet to Teltonika RUT240 4G

I'm looking for advice on configuring failover internet to a Teltonika RUT240 (WAN2) in passthrough mode.
 

As soon as I plugged in the WAN2 interface the connection would drop until I added a firewall policy to allow traffic over WAN2 on investigation I found that a static route was being created with the same admin distance as WAN 1
 

I tried configuring it using the guide here which almost worked except that some traffic was still being routed out of the WAN2 interface (Teltonkia) when both connections were up despite a higher priority on the default route.
 

I determined this as my WAN IP as detected from a connected device was the IP of the 4G connection and tracert went out over the 4G network.
 

In addition to failover internet the Teltonkia connection will be used for emergency VPN access which I have tested and is working.
 

The above was tested on a 60D running 6.0.4 but will be used in production on various models running 6.4.6 and 6.0.12.

The other problem is having to configure duplicate policies for WAN1 and WAN2. Should I be looking at using SD-WAN instead?
#1

0 Replies Related Threads

    Jump to:
    © 2021 APG vNext Commercial Version 5.5