VPN Manager - hub behind NAT device

Author
malakibrahim
New Member
  • Total Posts : 1
  • Scores: 0
  • Reward points: 0
  • Joined: 2021/02/17 16:51:40
  • Status: offline
2021/02/17 16:59:18 (permalink)
0

VPN Manager - hub behind NAT device

Hello 
I have a hub and spoke topology created via VPN manager on FMG, the Hub is behind a NAT device (hub is configured with a private IP address), where can I configure the public IP address of the hub? if the ISP is connected via two ISP can I configure two public IP addresses instead of only one? 
 
#1
sw2090
Expert Member
  • Total Posts : 896
  • Scores: 68
  • Reward points: 0
  • Joined: 2017/06/14 01:27:25
  • Location: Regensburg
  • Status: offline
Re: VPN Manager - hub behind NAT device 2021/02/23 00:26:21 (permalink)
0
a vpn tunnel (hub aswell as spoke) is always tied to an interface.
So tie it to the WAN interface you want to use.
The interface ip wil be the ip the tunnel uses as source ip.
 
There is also some way to use sd-wan but I never tried to.
#2
Jump to:
© 2021 APG vNext Commercial Version 5.5