How does [set split-tunneling-routing-negate] work?

Author
bvanhaastrecht
New Member
  • Total Posts : 5
  • Scores: 0
  • Reward points: 0
  • Joined: 2015/10/12 23:44:32
  • Status: offline
2020/10/15 00:18:21 (permalink)
0

How does [set split-tunneling-routing-negate] work?

Hi,
 
I'm trying to figure out how set split-tunneling-routing-negate works. The kb article is also not very helpful.
 
My goal is to route all traffic into the tunnel, but exclude some IP addresses. Current config without excludes:
split-tunneling : enable
split-tunneling-routing-negate: disable
split-tunneling-routing-address: "AllRanges"   (this is a range from 0.0.0.1-255.255.255.255 which is almost all, as you cant add 0.0.0.0/0 to a split tunnel config)
 
Now I want to exclude some ranges/ip's so I need to enable split-tunneling-routing-negate, but then the split-tunneling-routing-address starts to work as the excludes list. So how can I combine split-tunnel with destination ranges together with excluding some. I'm confused.
 
Kind regards,
Bastiaan
#1

1 Reply Related Threads

    sw2090
    Expert Member
    • Total Posts : 783
    • Scores: 58
    • Reward points: 0
    • Joined: 2017/06/14 01:27:25
    • Location: Regensburg
    • Status: offline
    Re: How does [set split-tunneling-routing-negate] work? 2020/10/15 02:56:39 (permalink)
    0
    well if you want all traffic to go through the tunnel you don't need split tunneling at all.
    You could filter the rest by policy.
    #2
    Jump to:
    © 2020 APG vNext Commercial Version 5.5