Hot!cannot query snmp

Page: < 12 Showing page 2 of 2
Author
smari
Bronze Member
  • Total Posts : 25
  • Scores: 0
  • Reward points: 0
  • Joined: 2015/11/10 01:11:11
  • Location: Iceland
  • Status: offline
Re: cannot query snmp 2019/08/27 06:19:26 (permalink)
0
If you are polling each HA cluster member directly ( I assume you have a individual ip on each management interface ) . 
You need to enable ha-direct
 
config system snmp community
edit 1
set name Community
config hosts
edit 1
set ha-direct enable
set ip 10.11.101.20
end
end
 
If you have only one deticated management for the cluster you need to enable the ha-direct in the ha config ( If i remember correctly) :
 
config system ha
set ha-direct enable
end
 

NSE7, FMG, FAC, FAZ .
1500D's, 1200D's, 900D's, 300D's, 200D's, 100D's and bunch of small stuff.
 
#21
smari
Bronze Member
  • Total Posts : 25
  • Scores: 0
  • Reward points: 0
  • Joined: 2015/11/10 01:11:11
  • Location: Iceland
  • Status: offline
Re: cannot query snmp 2019/08/27 06:23:52 (permalink)
0
By default the HA reserved management interface does not respond to management services

NSE7, FMG, FAC, FAZ .
1500D's, 1200D's, 900D's, 300D's, 200D's, 100D's and bunch of small stuff.
 
#22
alain
New Member
  • Total Posts : 14
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/07/22 01:07:32
  • Status: offline
Re: cannot query snmp 2019/08/30 07:21:28 (permalink)
0
Any comment ?
#23
alain
New Member
  • Total Posts : 14
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/07/22 01:07:32
  • Status: offline
Re: cannot query snmp 2019/09/09 00:07:04 (permalink)
0
UPgrade from 5.6.6 to 5.6.11 does not solve this problem.
I finally use another interface than the mgmt interface :  a LAN Interface, SNMP is now working.
I would appreciate to understand why a mgmt interface cannot be used for SNMP queries....
 
#24
Page: < 12 Showing page 2 of 2
Jump to:
© 2019 APG vNext Commercial Version 5.5