Fortimanager on Hyper-v upgrade from 6.0.3 to 6.0.5.

Author
jdixon
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/06/11 12:03:50
  • Status: offline
2019/06/11 12:05:48 (permalink)
0

Fortimanager on Hyper-v upgrade from 6.0.3 to 6.0.5.

I just upgraded from 6.0.3 to 6.0.5 and now the system doesn't have a NIC. I couldn't really find anything on correcting this but looking in CLI (through Hyper-V) I see the route and the ip address is set. The device can't even ping the gateway so I assume it is due to the linux OS not recognizing the NIC.
 
Any idea on how to correct this?
#1
jdixon
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/06/11 12:03:50
  • Status: offline
Re: Fortimanager on Hyper-v upgrade from 6.0.3 to 6.0.5. 2019/06/11 14:01:02 (permalink)
0
I ended up setting the IP again and it started working.
 
I ran:
  • config system interface
  • edit "port1"
  • set ip xxx.xxx.xxx.xxx 255.255.255.0
  • end
Then it started working again. Before that I did a SHOW and it did show the correct IP so I change it to a different IP, then changed it back. 
 
 
#2
Jump to:
© 2019 APG vNext Commercial Version 5.5