Hot!Setting up vlan fortigate 60e

Page: < 12 Showing page 2 of 2
Author
mahesh secure
Silver Member
  • Total Posts : 83
  • Scores: 1
  • Reward points: 0
  • Joined: 2015/12/10 01:04:48
  • Status: offline
Re: Setting up vlan fortigate 60e 2019/04/08 03:22:35 (permalink)
0
Hi,
 
 
also i see that all the interface is in untagged mode only. the port you have connected to fortigate must be tagged mode if you create vlan in fortigate interface. 
 
 
Regards
Mahesh
#21
jkchoa
New Member
  • Total Posts : 20
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/03/03 20:15:44
  • Status: offline
Re: Setting up vlan fortigate 60e 2019/04/08 17:50:24 (permalink)
0
Mahesh,
for #3. try connect another laptop in switch and set ip address as 192.168.200.13 and try to ping the 192.168.200.12
I tried a PC 192.168.200.251 and laptop 192.168.200.12, both can see each other
and cannot see the gateway 192.168.200.253 interface on the HP 1910 switch.
In my initial post, I thought we can setup VLAN on the fortigate, however as per analysis there should also VLAN ids
setup on the switch.  I tried asking HP forum guys about the unusual behavior of the hp1910, am not sure its working the way it should.
post edited by jkchoa - 2019/04/11 00:44:38
#22
jkchoa
New Member
  • Total Posts : 20
  • Scores: 0
  • Reward points: 0
  • Joined: 2019/03/03 20:15:44
  • Status: offline
Re: Setting up vlan fortigate 60e 2019/04/15 00:18:52 (permalink)
0
Hi Mahesh/Ede,

Can I ask for your suggestions what to do next? Here's what I plan to test further:
After creating the VLAN: 10 on the FGT with IP 192.168.200.250, and I create also VLAN: 10 on the HP1910 switch with interface IP 192.168.200.253, connect the two devices via tagged port of the HP1910 switch,
then on the PC or laptop I assign IP address 192.168.200.11 with gateway 192.168.200.253
Will the above VLAN work ?
#23
Page: < 12 Showing page 2 of 2
Jump to:
© 2019 APG vNext Commercial Version 5.5