Hot!Policy route can't select sd-wan

Author
lichunkei
New Member
  • Total Posts : 2
  • Scores: 0
  • Reward points: 0
  • Joined: 2017/12/27 18:52:00
  • Status: offline
2017/12/27 19:03:25 (permalink)
0

Policy route can't select sd-wan

Hi all,
 
I can't setup a policy route that the outgoing interface is sd-wan. Please help.
 
#1

3 Replies Related Threads

    MikePruett
    Platinum Member
    • Total Posts : 676
    • Scores: 15
    • Reward points: 0
    • Joined: 2014/01/08 19:39:40
    • Location: Montgomery, Al
    • Status: offline
    Re: Policy route can't select sd-wan 2017/12/28 06:45:00 (permalink)
    5 (1)
    The purpose of the policy route would be to use one of the interfaces that is a member of the SD WAN. unless you are using SDWAN for something other than internet pipe load balancing etc.

    Mike Pruett
    Fortinet GURU
    #2
    lichunkei
    New Member
    • Total Posts : 2
    • Scores: 0
    • Reward points: 0
    • Joined: 2017/12/27 18:52:00
    • Status: offline
    Re: Policy route can't select sd-wan 2017/12/28 17:37:47 (permalink)
    0
    Dear Mike,
     
    Thanks for your reply, I also want to know if I want to route the 123.123.123.0/24 traffic to internal but only 1 IP like 123.123.123.123/32 to sd-ram? normally I will setup a policy routes to do that. 
    One more question, what is the priority routing for static routes, policy routes and sd-wan?
    #3
    mahesh secure
    Bronze Member
    • Total Posts : 25
    • Scores: 0
    • Reward points: 0
    • Joined: 2015/12/10 01:04:48
    • Status: offline
    Re: Policy route can't select sd-wan 2017/12/28 23:23:12 (permalink)
    0
    Hi
     
    Did you check the SDWAN rules ? you can also route traffic with SDWAN rule. you can give specific wan interface in SDWAN rule
     
     
    Regards
    Mahesh
    #4
    Jump to:
    © 2018 APG vNext Commercial Version 5.5