Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
sfareg
New Contributor II

not found wan1 to add at wan-load-balance

i want to configuration load-balance 

but found wan2 only

2 Solutions
neonbit
Valued Contributor

It's because WAN1 is already being referenced in policies, routes etc.

 

You need to remove all references to WAN1 before you can then add it to the wan LLB.

View solution in original post

ERNESTO_GARÍ
New Contributor II

Greetings, you must deactivate routes, policies and objects that are associated with that interface, so that you can appear in the WLLB

View solution in original post

4 REPLIES 4
neonbit
Valued Contributor

It's because WAN1 is already being referenced in policies, routes etc.

 

You need to remove all references to WAN1 before you can then add it to the wan LLB.

ERNESTO_GARÍ
New Contributor II

Greetings, you must deactivate routes, policies and objects that are associated with that interface, so that you can appear in the WLLB

sfareg

thanks

fred339
Contributor

One way to preserve the policies, etc. instead of deleting them and starting over is to assign them to an unused interface.  So, if they are something like INSIDE > OUTSIDE and going to WAN1, change them to go from INSIDE > internal4 temporariliy.

Then, when WAN1 is where you want it, you can change them back.  

Easier to preserve things this way....

Fred Marshall
Fred Marshall
Labels
Top Kudoed Authors