Is there a way to increase the time between a pause during dialing and
the phone automatically dialing the numbers already entered? For
example, I want to dial a phone number, I start dialing XXX-XXX then
pause to look at the last 4 digits, if I paus...
I have noticed when calling into certain automated phone systems, the
FortiFone/FortiVoice is either not sending the complete tone or the
other end is not receiving it or interpreting it as some of the phone
systems are not responding to the button p...
Our FortiFone-480 desk phones are randomly experiencing ring delays
after upgrading the firmware to 3.0.12.225. When there is an incoming
call, some of the 480 phones will not ring for about 15 seconds. Not
only is the phone not ringing but the SIP p...
I have been seeing some sporadic Gh0st.Rat.Botnet and Bladabindi.Botnet
notices in FortiClient EMS for a particular system. Is there a way to
find out if this is incoming or outgoing? If it is incoming I am not
that concerned. If it is outgoing I wou...
Thank you, Farina, for pointing me in the right direction. I found the
proper setting in the FV100E to be the "Digit map pause timer" setting
under "Phone System | Profile | Phone", then editing the profile for the
particular phones being used.
I made these changes including removing the virtual-switch reference.
Everything worked except for the FortiAPs (FAP) that are connected to
the FortiSwitch (FS). The FAPs are visible to the FortiGate (FG) through
device discovery. However, the FAPs a...
In case you have not tried this or anyone else is wondering how to do
this. You could try saving an unencrypted config file, open the config
file in a text editor, change the type from "set type hard-switch" to
set type aggregate", save and load the ...
Graham,That was it. The setting was under Phone System | Profile on the
FV-100E though. Had to change it to Inband and now the problematic
automated systems do work. Thank you.
