Hello FortiSwitch integratorsAny one managed to make it work a
FortiSwitch connected to a pair of VLAGed Lenovos.FortiSwitch 124F /
7.2.7 unmanagedLenovo RackSwitch G8124-E / 8.3.5It was working fine with
Cisco but couldn't manage to do it with Forti...
Hi FortiSwitch adminsI have a new FSW 124F with OS 7.2, standalone.When
I go to menu Switch > Physical Ports, when I select one port and click
edit I have this error.(URL
https://1.2.3.4/switch/physical/edit?name=port1).Any of you has seen
such error...
Hi FortiSwitch adminsWhat is the difference between these
two?factoryreset Reset to factory default now.factoryresetfull Fully
reset to factory default now.
HelloI have FGT 200E OS 7.0.14 with two FSW 124F OS 7.2.7.Multiple VLANs
are needed on the switches (lets say 10, 11 and 12) but only one must be
on FortiLink (VLAN 10), especially on the inter-switches link. This is
because of some topology concerns...
HelloIn the latest FSW-FOS compatibility matrix they said FSW 7.2.6
recommended with FOS 6.4.15, but they didn't mention for FSW 7.2.7.Since
this is a patch, is the information confirmed to be correct or they just
missed to mention it?
Hi FranciscoI'm surprised that your ISP asked you what is the MAC
address of the device! So what if you change the device? First you may
check if the static address has been assigned automatically by your
provided, because some providers do that, I m...
Hi FranciscoYou can use the new static IP either on FG or on the ISP
router.In case you need to configure the new static IP on FG then make
sure your ISP router is in bridge mode.If it is already in bridge mode
then the new static IP you received can...
The I guess there is some firewall protecting your EMS Cloud, right?
That's where you need to allow the required traffic initiated from FGT
public IP. Is this done already?