Hi, SetupI have a large network which is described in the image below.
The image is simplified. In my real network there are about 40 switches
like "Switch C" -- switches that are connected to both "Switch A" and
"Switch B". Also I have a Fortigate H...
I want to create a VLAN. I do not want to create a VLAN Interface. I do
not want routing/gateway capability. I do not want the
FortiSwitch/FortiGate to take an IP address on this VLAN. Is this
possible? I'm beginning to think that in the FortiWorld i...
Thank you -- can you think of ANY configuration of ISL that will cause
packet loss between "Host 1" and "Host 2" when "Switch D" is connected
to "Switch C"? Please consider if I DESIRE packet loss between "Host 1"
and "Host 2" when "Switch D" is conn...
Thank you all for your replies. A couple of comments which I should have
included in my original post: The dropped traffic between "Host 1" and
"Host 2" is on the same VLAN. No routing. The fortigate does not see the
traffic (in the logs), which is w...
Bryce: thank you. I was able to edit the VLAN interface and set the ip
to 0.0.0.0/0.0.0.0. I believe that was the default, but when I created
the "VLAN" originally and left the default I was told "invalid ip" which
made me think I had to set it to so...
Hi Ken, Thank you for your reply. I don't want anything talking on the
LAN, except some devices that I have identified. I don't want the
fortinet equipment even consuming one of the precious IP addresses on
the subnet. I want a guarantee that nothing...
