I am trying to figure out how to configure a IPSEC vpn with NAT for
multiple ISP's. Right now I understand how to do it with just one by
created the IP Pool, Virtual IP and using those in the firewall rules
but the issue is I need to do this with a V...
I just upgraded from 6.0.3 to 6.0.5 and now the system doesn't have a
NIC. I couldn't really find anything on correcting this but looking in
CLI (through Hyper-V) I see the route and the ip address is set. The
device can't even ping the gateway so I ...
I ended up setting the IP again and it started working. I ran:[ul]config
system interfaceedit "port1"set ip xxx.xxx.xxx.xxx
255.255.255.0end[/ul]Then it started working again. Before that I did a
SHOW and it did show the correct IP so I change it to ...