The firewall has a Primary and Secondary internet connection.The
Primary(wan1) is PPOE and IP/DNS/GW are automatically assigned (the IP
is static, but is assigned via PPOE). The default route assigned is
given a distance of 5.The Secondary(wan2) is a...
When you create or edit an ADOM this setting give you a choice of Select
all or Unselect all. What does this setting do? All the documentation
I've been able to find just says to choose one, never says what one does
compared to the other. My ultimate...
I've done this countless times on non-Fortinet firewalls so the concepts
are far from new for me. I want to be able to access the management web
page from the outside, from a specific IP address.I do not want to limit
in any way the access on other i...
OK, it looks like there were some old policy routes that were causing
problems, I also found that not all the fail-over routs had the same
distance. Removed the policy routes and fixed the distance, cleaned up
the priority as well. And it all looks t...
It is my understanding that link-monitor uses the combination of
interface and gateway to determine which route to remove from the
routing table. Or are you referring to the address I ping to determine
the interface can pass traffic, in which case I ...
Just to add to the confusion, the primary internet is down this morning,
no traffic is being passed. But the PPOE is still getting an IP, GW, and
route to the gateway. This stresses why I used the link-monitor and not
just relying on PPOE dropping an...
I'm little nervous about changing the defaultgw setting remotely, this
may have to wait until I'm back on-site. The reason is the the PPOE is
creating 2 "connected" entries in the routing table. One is
xxx.xxx.xxx.1/32 on ppp1 which is the address of...
jamesmeuli thanks that's just what I was looking for.A quick little CLI:
config system interface edit wan1 set allowaccess ping https fgfm next
endconfig firewall address edit 1-public-IP set subnet xxx.xxx.xxx.xxx
255.255.255.xxx next edit 2-public-...
