Hi All, i have a question about IPsec Site to Site Tunnel ... while
establishing the tunnel how is the configured source interface
communicate to the destination tunnel address ??? is it through routing
table or it just send traffic out of the config...
Hi All, Is anyone know how to create a policy hitcount report from
fortianalyzer?? or even what is the sql quary to poll hitcount recored
from specific policy ???
Is there any issue between IPsec VPN or SSL VPN and WAN LLB ??? cuz till
now i dont now how IPsec VPN will decide to get out from what interface
under WAN LLB configuration
well i cant delete the default route , but what you are saying mean that
if you have load balancing default route you cannot create IPsec tunnel
through one of the ISPs !!!
are you sure that its using the routing table because am configuring a
source interface shouldn't it sent the packets out of this interface
directly ???
this is not what i meant not the tunnel destination network what i mean
the destination tunnel IP the real IP that Source Tunnel connect to
establish the tunnel.