I am trying to setup a FortiWifi 90D. My Internet connection consists of
a dynamic IP provided by a Thomson DCM476. The modem works fine with my
old Asus router. I followed the directions in the cookbook to setup
NAT/Route mode on the FortiWifi, but ...
>You could try to change the speed setting of the port connected to the
modem. 100full etc.I tried that previously. No luck. I am pretty sure I
have adjusted every configuration under the WAN1 interface. The modem
itself doesn't have a configuration ...
After verifying the specs on both the FortiWifi 90D and the Thomson
DCM476, I confirmed that they both have auto-MDIX and wouldn't require a
crossover cable. My previous Asus modem worked fine with a
straight-through CAT 6 cable from the same modem, ...
I connected WAN1 and WAN2 with a CAT6 cable and both the WAN1 and WAN2
status LED lit up. I have used 8 different cables that range from CAT5
and CAT6. I haven't tried a crossover cable, but I would assume the
modem and Fortigate have the ability to ...
Any help would be appreciated. I have spoken to my ISP several times and
they are telling me it is a configuration issue with the router and they
can no longer assist. I'm on f/w 5.4.3 build 1111 if that makes a
difference.
