I have 16 sites on L3VPN and would like to connect all the sites to FG
240D. What are the steps and configuration it requires in routes, BGP
and policies? I have terminated the main router of the MPLS on my core
(Catalyst 6500) and have created the I...
Offcourse yes he meant so, he must have a policy for all the VLAN's
(including 2 VLAN's) towards WAN1 and in case if WAN1 gets down, the
policy based route will allow only 2 VLAN's in subject to go from WAN2.
Indeed there is a need to create a link m...
Absolutely right as lobstercreed suggested, you need to create policy
routes for the specific VLAN's traffic to go through WAN2. There is no
need to create OSPF either on switch or FW. Regards,Syed
Hi,first make sure you have configured the inside and outside NAT. ISP
must have given you some router, make sure the NAT is done, then make
sure the interface of FW is configured with the correct IP and proper
routing is done. Failover can work when...
You can ask the following: - number of users (If FW will the be gateway
to internet browsing, however this is the most suitable scenario, it
gives the opportunity to client to provide more controlled internet
browsing to users) - number of devices di...
