Hello all, I have an MPLS circuit and I want to run an encrypted end to
end connection over it using two Fortigate 60E boxes. I am trying to
follow a cookbook recipe from the KB on using a virtual-wire and an
IPSec tunnel. Its been challenging becaus...
I have a FortiGate 61E at a remote site with a VPN tunnel back to my
main site. I have had a problem where my Windows clients will detect a
new network, and will identify it as "Network 3". That is, when you
choose a type of Network in Windows 7, you...
ispcolohost wrote:I'm considering abandoning the attempt and moving to a
linux-based vxlan bridge downstream of the Fortigate. That is not a bad
idea! That leaves me with another device that I have to secure and keep
updated. But there are plenty of ...
I would also like to see a working example. I have had a case open with
support for a week or so, with no response. And I am under the gun to
get this working. I have a successful IPSec tunnel, and traffic is
passing from my remote FortiGate to my Pa...
Turns out, it was the FortiGate that was to blame for this one. Spectrum
is off the hook! After battling this issue for months - I called into
support and opened a new case for this issue (I believe that makes three
times I have done this). Got someo...
rwpatterson wrote:If dynamic, I would set the cable modem in bridge
mode. Funny you should say that. We always put in our own firewall, ask
for a static IP address, and request that the cable modem be put in
bridged mode. But as much as I tried, I co...
