Hi.I've a strongswan server and a Fortigate 50E device running v6.0.9.
This is the configuration on the fortinet side In strongswan I
have:config setup charondebug="ike 3, knl 3, cfg 3, net 3, esp 3, dmn 3,
mgr 3" uniqueids=yes strictcrlpolicy=no con...
Hi.Since when I've upgraded my FortiClient installation on MacOS I'm
unable to connect to a customer's SSLVPN. All I get is a generic unable
to connect message, I tried downloading debug log from preferences but I
see nothing. I'm sure the VPN is wor...
I managed to get it working by creating a new secret and pasting it
directly into the GUI and in ipsec.secrets. After that P1 was up, still
mismatch for P2. I changedesp=aes256-sha256-modp3072and finally both P2s
were up. Thanks again for the help
I've upgraded to 6.2 but things seems to be worse now: strongswan is
unable to find PSK.I tried different formats of ipsec.secrets but it's
unable to find it: 53:74:65:6c:cc:bc : PSK "abc"@forti_public_ip : PSK
"abc"Stelle : PSK "abc"%any : PSK "abc"...
I finally was able to have a look at this again... Unfortunately without
success. I did some minor changes to your config:* used rightid and set
the corresponding on the firewall* had to omit set net-device disable
because the device I'm currently te...
Thank you very much for your reply. I picked the configuration from
Strongswan examples. Also I found there are these limitations, that's
why I did a single ipsec config with both subnets. I will try a fresh
config based on your suggestions, will let...
