My VOIP vendor states that 2% of calls are not getting a response. They
state that it is probably a problem with the "NAT UDP pinhole timeout".
They recommend a value of 60 to 300 seconds. I do not find a place to
set the UDP timeout value. I was hop...
I have a VPN tunnel defined which comes up OK. Traffic on the far side
is coming through the tunnel without a problem (CISCO RV042 device). On
the Fortigate 60D (5.0.310) I have a rule defined where the source is
DMZ, 192.168.18.0/24, destination is ...
I have a block of IPs from my ISP 174.xx.xx.129/27. I have a number of
VIPs and policies set up to direct various of these IPs from WAN1 to the
correct devices on my internal interface. I have a need to give one of
the IPs as-is to another router for...
For anyone following. The document above is talking about the
session-ttl. That is not the same as the UDP or ICMP ttl. So what
finally solved the issue was the following: config sys globalset
udp-idle-timer 300end
That was absolutely the problem. Can't tell you how many times I was
comparing the GUI for this tunnel to other tunnels that worked.
Unfortunately this parameter is not visible in the GUI. I always set up
the tunnels using the GUI never the CLI. Hind...
following configurations cut from a backup showing the relevant parts
(external ip's changed). policy 30 is the one that i assume would push
the traffic down the tunnel but appears to be ignored. rule 31 if
enabled catches the source and destination ...