Hi everyone,My ISP just changed my connection configuration and I now
must use a VLAN to connect my fiber to them. I've created the new VLAN
interface off the WAN port interface and I can connect to my ISP now.
The problem is I have quite a few VIP's...
Hi,I got a Linux box setup on a DMZ with the IP 192.168.30.2 connected
to my FG 30E DMZ port. The Linux box is setup with iptables to forward
all traffic from eth0 to wlan0 using these parameters:# Forward LAN
packets to the WAN.iptables -A FORWARD -...
Hi guys,I have a FG 30E and I've setup a static route to a Cisco 2600
router which is routing between token ring and ethernet on different
subnets. The Cisco 2600 router has its ethernet NIC configured as
192.168.1.101 and the token-ring NIC as 192.1...
Hi,How can I change the Fortigate cloud email address on my FG30E? I've
tried various CLI commands but it does not work. When I click on the
GUI, Security Fabric, Settings, Account Activate. I get the old email
address. No way to change it.Thanks,Rob
Hi,I have an FTP set-up on a DMZ and I use VIPS to forward the ports too
it, as we only have one public IP address, which is assigned to the FG.
I have a policy setup to allow access from internet to it. This all
works fine. My problem is the FTP ser...
Resovled. The problem was the old entries to the WAN interface were
classed as "duplicates" So I had delete all the old entries and create
new ones with the new VLAN interface. Even though I was creating a
completely new mapped IP destination it did ...
Thanks for the reply. So if there is an existing VIP listed using the
old WAN interface with the DHCP assigned IP address from the new VLAN
interface but it has a different Mapped IP address than the new VIP I am
creating, would that be classed as a ...
Thanks for the reply. ok So the new VIP I am creating is using the DHCP
assigned IP (NADUNET2) and using a completely different LAN IP to
forward the ports too. Is that classed as a duplicate because its using
the DHCP assigned IP from the ISP?FG-HOM...
Right found the fault guys. I needed to add the 192.168.4.0/24 subnet to
the ID 7. I had it on the other end but not this one. All working. Many
thanks for your help everyone!!
Thanks Damian,I see its the implicit deny policy 0 which is blocking it.
hmmmm FG-HOME # id=20085 trace_id=1 func=print_pkt_detail line=5607
msg="vd-root:0 received a packet(proto=1,
192.168.1.8:42772->192.168.4.1:2048) from lan. type=8, code=0, id=4...