How to get AON single fiber (BiDi) FTTH/FTTx directly attached to a
FortiGate without using any provider CPE? We have a small office where
the internet connection is provided as "Gigabit Fibre DSL*!!1" with the
footnote "ADSL 500M down + 100M up over...
We have a Fortigate 100E running FortiOS 6.2.3 with two FSW 448D
switches.The switches are connected via four Gigabit ports each to the
Fortigate (no 10G interface in the 100E) using "set
fortilink-split-interface disable" to activate all 8 ports in ...
Hello,(FortiOS 5.6)the Hardware-Switch on FortiGate 61/81E seems to be
limited to the numbered ports (internal1 to internal7), the Ports
labeled WAN1, WAN2 and DMZ can only be used in a Software-Switch. I am
not concerned about performance (the few %...
Hi, For some reasons we would like to be able to have a FortiGate
built-in DNS server to send negative answers (NXDOMAIN) for all
queries.The easiest way to do that on any bind/windows DNS server is to
have a master zone for the root zone (".") witho...
Hi,There have been a few similar posts, but none with the same
constellation (OS level and topology):We have a single FortiGate 100D
running FortiOS 5.6.3 managing a stack of two FortiSwitch 124E with
S124EN-v3.6.3-build4269.Connection is:FortiGate F...
chilimac02 wrote:Did you find a solution to this issue? I'm having a
similar issue myself. Even a link to another post would be helpful :) We
rebooted both fortiswitches and the fortigate during a maintenance
window and also upgraded the firmware.Thi...
emnoc wrote: You know that will not work out in the end , I believe
dot.com has like 100+ millon zone and that 1600 for TLD your quoted is
well over 5k. No, the point is we need an empty zone. This is the only
way to make a DNS server respond with NX...
The reason is actually pretty simple:1.) The fortigate is the only
device on site (apart from dumb layer 2 switches).2.) We need an
authoritative DNS server that MUST responds with NXDOMAIN negative
answers and not just timeouts or servfail errors (a...
gummi@sensa.is wrote:can be done with diag sys top -- and get the pid of
the cu_swtpd service which in this case was ‚cu_swtpd 923‘Then kill the
service with – ‚diag sys kill 9 923‘ regardsGudmundur Does that affect
traffic?
