Hi everybody, I have big problems in understanding hub and spoke VPN.The
Hub i a FGT 60C with OS 5.2 Patch 11The Spokes are two third-party
Routers (AVM Fritzbox 4020, german manufacturer) as
dialup-IPSEC-connections What i have is:two route-based IP...
Hi everybody, here´s my setup: Internal LAN and DMZ Ports are used on
the unit and there is a policy based dialup ipsec set up for remote
users to access Internal LAN The Question is if I can add access to DMZ
to the existing dialup IPSEC VPN and how...
Hi everybody, i try to get the following setup to work but i can´t find
a solution: i have a FGT-60C in the headquarter and a FGT-60D in another
office. Both are connected with site-2-site VPN interface mode.I also
have 3 FortiAP 14C connected to hea...
Hi there, I have a Fortigate 60B Firmware: v4.0,build0632,120705 (MR3
Patch 8) When performing an ftp upload he connection is dropped after
600 seconds. What I can see in session monitor is that expiry is always
about 599 und duration counts up. When...
Hi together, yes, i configured the Fritzboxes following that article you
mentioned. Diag debug flow shows me this: FGT60C-# id=20085 trace_id=5
func=print_pkt_detail line=4479 msg="vd-root received a packet(proto=1,
192.168.124.101:1->192.168.121.11:...
I´m afraid it does not. But i guess, missing routes and policies are the
reason. But I am not sure which routes and policies have to be set.I set
up the site2site vpn with the wizard, so there are 2 policies, internal
to ipsec tunnel interface and ip...
Hi Bib, I can not try active ftp my application forces me to use passive
ftp. I did a factory reset now and tried with ony internet access
configured - same problem, the only difference i see is that with
factory defaults timeout is 3600. But this al...
the settings set end-port and set start-port did not work, but the
set-protocol did work. Here´s my new settings: config system
session-ttl set default 600 config port edit 21 set protocol 6 set
timeout never next end end But that did not help. I gu...
