Hi all, I'm running a pair of 60E's on 5.6.3 as a HA cluster. I've setup
a VLAN interface for management to the root VDOM, given it an IP, and
also given each member a management-ip in the same subnet. So for
example, vlan interface is VL100-MGMT, IP...
Thanks Toshi. I may try out some of that. We're also using VDOMs. We
don't use dedicated management interface in the HA config, but you raise
a good point about reapplying the config. Maybe I should remove the
management-ip and re-enter it to see if ...
Oddly, my monitoring tool has sent me 3-4 alerts over the past few days
whereby the B node starts to respond to pings on its management-ip for
about 1 minute and then stops again. Rich
emnoc wrote:On FW1B login and do the following; get router info routing
connect diag ip arp list Do you see anything ? Nothing on the routing
table: FW01B (root) $ get router info routing-table connected FW01B
(root) $ get router info routing-table a...
ede_pfau wrote:You might try to set the originating IP address before
you ping:exec ping-option source a.b.c.d Otherwise, it might pick some
IP address from a 'nearby' FGT port which just won't fit. Oddly, the
"source" keyword is not available from t...
emnoc wrote:This is not a bug, you can only get to this via the Cluster
Node that holds the Layer3 RIB and that address , is 10.0.100.12
pingable ? Not 100% sure what you mean, but from node A (active) I can
ping 10.0.100.10 (the VIP), 10.0.100.11 (i...
