Hi, I have two FortiADC's running the latest firmware 5.0.1. I setup
both devices with default values and after this initial setup I
configured active-active on them. After the active-active setting the
GUI is unreachable and the devices cannot be pi...
Hi Boneyard, In the ADC from the GUI you go to Network > Interface, and
here you can give up what the IP address of each port should be. But you
have to leave this untouched, there is an specific setting for
management IP. You can say management port...
Ok here is what I did wrong, and I found out using help from Fortinet. I
put the IP on the interface which doesnt work anymore after
Active-Active is setup. After Active-Active setup you must remove the IP
from the interface and on each device create...
@skippy and everyone else, Version 5.2.8 seems to be the solution! We
upgraded our firewalls 3 weeks ago to 5.2.8 and there are no issues so
far. Hope this helps you guys.
