Hello guys, I have a Fortigate with FOS v5.2.3 running and advertising
some local loopback /24s and interface /32s via OSPF to the
neighbours.What I can't figure is to block the advertisement of the /32
addresses by using either router access-list or...
Hello guys, I added some 311Bs and 100Ds to Fortimanager, but I need to
create zone/interface mappings. When I try to create a new zone, I can
only do VLAN instead and don' t find the option to create it after the
device is already in FMG running in ...
Guys, That is a simple option on my D-Link home modem, but I don' t see
anywhere the same available on my 60C. Is it possible to list hostnames
without running an internal DNS server and display log records without
IPs? Also I' m using DHCP server on...
Hi guys, I have a 60C and want to configure it with my ADSL internet
connection, but the lines comes via an RJ11 phone line connection and
the WAN1 interface on the 60C is an RJ45 one. Can I plug in the 4-wire
phone jack to the 8-wire ethernet port o...
diag sniff packet any 'port 161' 4 0 l If you don't see any packet
hitting the Fortigate on this port than something else is blocking the
access.All you have to do to enable SNMP is what you described in your
first post.
I wouldn't recommend any new GA release in production before at least
patch 4 is out unless you want to go cutting edge.v6.2 introduced 200+
new features and changes and you can risk to hit an unknown bug if you
used it. But also the issue descriptio...
Thank you Andrea for the response, and it all makes sense and was very
helpful. It turned out at the end that when I imported the firewalls
under the ADOMs in FMG the zones will not just automatically pop up out
of nowhere. Only when I imported the n...
