Hi there!I have a setup where I would like to allow ICMP port
unreachable packets, even though there is no matching session in the
'diag sys session list' table. FortiOS 5.4.3, with NP6. An old KB
document states this
http://kb.fortinet.com/kb/viewCo...
Hi! Let' s say that I have a set up like this: Fortigate 600C prio 200
<---4x cat6---> Switch-1 Fortigate 600C prio 100 <---4x cat6--->
Switch-2 Is it possible to configure, that if less than N number of
ports are active in an aggregate, the aggregat...
Hello! How do you go about routing in a full mesh created by the VPN
console using a fortimanager? Let' s say that I want to use BGP. The vpn
console seems to only create interfaces without IP addresses. Is any of
this documented? Searching on google...
Hello, again! I have a very weird issue. Most of our users can connect
just fine to the ssl vpn, using forticlient. However, a few (which are
all at the same location) can' t connect. I can see the packets arriving
at the fortigate, but they get drop...
Hi! This is the second time I see this issue, on the same device. I have
an 80C running 4.0 MR3 Patch 3. I' ve just created two IPsec interfaces
(two tunnels), and only one of them, the later one created - can be
added to a zone. Both has no referenc...
Hi! One thing you can do, is to enable IPv6 over the link you want to
send youtube (Google) traffic over.It's more of a side effect, because
IPv6 records takes priority over IPv4 DNS records. /Stefan Lindblom
Just an update to what happened: I followed the upgrade path, and did
the following: Upgrade to 4.3.10 - when fine, took ~5 minutes. Upgrade
from 4.3.10 to 5.0.2 - the firewall never came back up. Did not get any
output in the console on reboot etc. ...
Hm okey. As I wrote earlier in this thread, it started working for me
(again) using windows deployment services, on a windows server 2008.
...pxebooting a new Lenovo laptop.