Hi all, I'm installing Symantec Endpoint Protection 14.3 on a new
laptop. FortiClient 6.2 and the new 6.4 aren't working. The "FortiClient
VPN Service Scheduler" is not starting. Removing SEP 14.3 let the
service start. No issues with SEP 14.2.Additi...
Hi all, the release notes are not showing the FGT 60E as supported
models. The firmware itself was released in the firmware section of
5.4.6 and 5.4.7, but the release notes are confusing me. Also the new
firmware is shown in the GUI, but there a war...
Dear all, I have this scenario:Site DC - Datacentre in GermanySite
France - Branch Office in ParisBoth locations have a FortiGate and their
own Internet connection (SDSL). This connection is used for IPSec Phase1
Interface Mode Tunnels to establish t...
Hi, we have no solution, but a kind of new "solution". Due other
reasons, we are removing SEP and no classic AV anymore. We are using a
combo of Windows Defender and Malwarebytes now. The overall speed on the
client is better too. Well, Symantec disc...
Honestly, I had no time to check it. But a quick check showed no
detections on that client. SEP Manager shows everything as green.With
release of an update for 14.3, I'll check again.
Thank you for your quick response.I've seen the special branch info, but
I don't know what it means. Not beeing in the supported models section,
is more confusing the helpful. Also the warning message in the GUI.
Hi localhost, thank you for your answer. I wasn't aware there is an
interface which is configurable with IP. I configured the IP and also as
the gateway for the policy based routing. But I can't get it working.
I'm also not sure which firewall settin...
Hi localhost, thank you for your answer. I wasn't aware there is an
interface which is configurable with IP.I configured the IP and also as
the gateway for the policy based routing. But I can't get it working.
I'm also not sure which firewall setting...
