We' re using a Fortigate 200A in our main corporate office which I
purchased and installed with around 100 total employees and 3 Branch
Offices. Now we' re up to around 250 employees and 11 Branch Offices.
Each office is connecting into the 200A via ...
We' ve just had a backup fiber connections installed at both our main
corporate offices about 10 miles apart. Both locations have Fortigate
200A with the latest firmware installed. Currently the locations have a
single site-to-site VPN setup (Site 1 ...
It' s been 5 years since I' ve studied/brushed up on my subnetting
skills so i' m a bit rusty. I have run into an issue in one of my
offices. The main interface is currenlty running on
192.168.5.1/255.255.255.0 for about the last 4 years. We have sin...
It' s been 5 years since I' ve studied/brushed up on my subnetting
skills so i' m a bit rusty. I have run into an issue in one of my
offices. The main interface is currenlty running on
192.168.5.1/255.255.255.0 for about the last 4 years. We have sin...
It' s been 5 years since I' ve studied/brushed up on my subnetting
skills so i' m a bit rusty. I have run into an issue in one of my
offices. The main interface is currenlty running on
192.168.5.1/255.255.255.0 for about the last 4 years. We have sin...
Thanks for all the responses. Just looking at a throughput spec
comparison of a legacy 200A model vs. a 300C shows a big difference. 150
Mbps vs 8 Gbps. Is there any good method of choosing the next model for
upgrade?
Thank you for confirmation. So as far as routing goes, traffic will only
go through the secondary site-to-site, as defined by my priority and
distance, if the higher priority connection drops. Is that correct?
Quick question, if I do a WAN ZONE with WAN1 and WAN2. How would I setup
site-to-site VPN? 2 different Phase 1s since they' ll be connecting to 2
different public IPs?