Hello, I've come across fgt100d HA installation where internal Ip
doesn't show in tracerouteWhat I get.>tracert -d 8.8.8.8 1 1 ms 2 ms 1
ms 2.2.2.2 2 4 ms 3 ms 3 ms 1.1.1.1... ^C What I would like to
get>tracert -d 8.8.8.8 1 1 ms 1 ms 1 ms 192.168.10...
Hello, I' m curious is there a possibility to block/quarantine mail, if
TO: and CC: fields doesn' t contain users from protected domain? code we
are running is v4(MR3p1)
Hello, how can one check counters (rx/tx/errors/status) on separate port
of " internal" ports when operating in " internal-switch-mode switch"
eg. diagnose hardware deviceinfo nic [???]
Planning several new setups with FG 100D (nat mode) On Uplink we are
terminating „trunk” several vlans using L3 interfaces. Is it
possible to bridge one of those vlans transparently (without L3) to some
other physical port. (other vendors address...
Hello, Having a new deployment with couple of dozen FGates +FMG. FG300c
– v5.0,build0128 (GA) FMG 200d – v5.0-build0076 121101 (GA) ADOM
version is set to 5.0 As it’s a new installation – figured out to
roll straight with the newest FortiOS. ...
adikad wrote:with new FortiOS5.4 you can now have a scheduled auto
config backup ! Is it possible to run script only upon
configuration changes or revision saves.This would make more sense if
there are units with occasional changes.
Thanks for looking into this. 1st trace issued from windows, should be
ICMP 3rd while testing: set allowaccess ping https snmp http fgfm As
from your trace with UDP it's obviously blocked, therefore showing * * *
In my scenario - hop simply doesn't s...