Hey volks, I have the following setup: 1 Datacenter: 1x Fortigate 50B
with fixed IP 1 Branch Office: 1x Netgear N300 Router with dynamic IP
(registered DDNS service) VPN Interface mode setup is done and tunnel
comes up successful. However, after the ...
hey all, I have setup two fortigates on different locations, they' re
initiate a tunnel successfully and i can access the internal network
behind fortigate 2 from fortigate 1. When i establish a forticlient
connection from home to fortigate 1 i can a...
Hey volks, I have two Fortigate 50B in use, one on the Datacenter with a
static IP, the other with dynamic ip (using DDNS dyndns.info) on a
branch office. The VPN tunnel between these both fortigates works fine.
The Client Login with FortiClient on t...
Hey Volks, After one night and a bit of sleeping i don' t think that the
dial-up solution ist the right one. I also doubt that it would not work
with DDNS and site-to-site connections. Ede wrote that it is not
possible that the FG resolves the hostna...
Hey, You need to add a policy on site 1 source: teleworker dial up
interface source net: teleworker network destination: site 2 interface
destination net: site 2 network Based on the type it could be that you
have to select IPSEC on type... and selec...
Hey Ede, Thanks for the update. I will give this a try. i have a second
FortiGate here in the branch office cause my first idea was exactly as
your suggestion. Unfortunately it is hard to configure with different
subnets, routing etc. only to have th...
Hey! Sorry, new to vpn, simple solution was to add the network on the
client side (absolutely beginner error) - after adding them all was fine
:) Greetz, Matthias
Hey Volks, I found the solution, don' t ask me why it was enabled (must
be a default setting as i never activate it via CLI) the set mode-cfg
was enabled. And because my FortiClient (4.1.3) does not support this
feature the Phase1 was dropped all the...
