Hi All, Our current network is MPLS based with Layer 3 handoffs at 6
sites, managed by a Fortigate Cluster that we manage at each
(advertising routes via OSPF to the ISP who redistributes across the
MPLS (I think using BGP). Sites links are quite slo...
Hi All, We have dual WAN setup with primary being an MPLS tail (WAN1)
and the secondary being a 4G/LTE connection (say WAN2 - via
FortiExtender) which is used for failover. To keep both in routing
table, default route is maintained for both with iden...
Hi All, We have an ' old' 3G modem performing internet termination in
front of a Fortigate 60C at a small remote site. NAT cannot be disabled
on the modem, nor does it support pass-through authentication allowing
the Fortigate to pickup an external I...
Hi all, We have a number of remote sites with dual WAN connections and
need to carefully manage bandwidth due to quotas and excess charges.
These tails are Satellite or 3G connections and suffer from periodic
outages. The sites are setup with an acti...
Hi All, Got a quick question which must be user error.. :) The CLI
doesn' t seem to want to accept the Set Encrypt Enable setting.. MYFGT01
# config log fortianalyzer setting MYFGT01 (setting) # set encrypt
enable command parse error before ' encrypt...
Same here. But I can't get both a BGP and Static default route to appear
in routing table with same distance configured (20). vStatic always
wins.. At least you got then both to appear! Running 6.05
could be the APN setting. On our 4G services there are specific APN's
which will provide an external routable IP and others that will provide
a private NAT's IP.
netwrkr wrote:We upgraded multiple locations to 5.2.8 in the hopes the
SIP ALG issue was resolved - negative. At some random point in time, the
FG will start natting SIP (port 5060) traffic using the IP address of
the outbound interface. When I say r...