Hello All, I have an issue about Dialup IPsec VPN user management, I am
wondering if I can setup one IPsec VPN with multiple dialup user account
in one user group. And with different account have different permission
to access LAN ? Or is it possible...
Hello everyone ! Pic below is the network infrastructure,we are going to
install Fortigate in transparent mode. the only issue is: a device in
the network is accessed with IP 192.168.100.101 but actually IP is
192.168.100.199. we need to add an one t...
Hi All,I created 2 administrators with super_admin profile.Both two user
can change the configuration.In the Event Log --> System section shows
configuration changed by which user, when and where.Is there any way to
get more details about what config...
Hi all, I setup a Dialup VPN with 2 Fortigate, Firmware version is
4.0MR1-Patch4 I follow the way how I config with firmware version 3.0
MR7-Patch 9 The tunnel is successfully been brought up, but peers are
not connected I check the log, the error me...
First of all , thanks for your kindness help, I load factroy default and
re-config all the VPN parameters. the Tunnel is up, peers connected to
each other, communications are fine. (I execute ping the remote gateway
on both side, 0% packet lost ) But...
I did it and it keeps coming up these messages ike 0:VPN_0:0: notify msg
received: R-U-THERE ike 0:VPN_0:0: sent IKE msg (R-U-THERE-ACK):
122.117.39.104:500->125.230.90.117:500, len=92 ike 0: comes
125.230.90.117:500->122.117.39.104:500,ifindex=12......
I followed the manual steps I unchecked NAT, but it still doesn' t work
here is the message in the error log : 2010-05-26 21:02:20
log_id=0101037125 type=event subtype=ipsec pri=error fwver=040004 vd="
root" msg=" IPsec phase 2 error" action=" negoti...
Hi Ede Here are the Phase 2 Parameters of both peer local Phase 2
parameter and Policy: config vpn ipsec phase2-interface edit " VPN-P2"
set keepalive enable set phase1name " VPN-P1" set proposal 3des-sha1
aes128-sha1 set dst-subnet 10.20.7.0 255.255...