Hi folks, I have a strange problem distributing traffic over sd-wan in
fortios 5.6.2We have 4 wan connections.Two of them are 100MBit down and
40 up.The other two are 16Mbit down and 1 up.I entered the bandwith of
each interface it's config.All conne...
Hello together, I'm trying to get my Fortigates registered via LLDP in
my Switches.This works perfectly on two FGT-50E, currently on 5.4.1.It
does not work on 3x FGT-90D and on one 110C. These are all on
5.4.somewhat firmware.What I did: edit "intern...
Hello at all, one of our customers needs to connect two sites with a
layer 2 connection transporting 5 separate vlans. At the moment the two
sites are connected like this: VLAN10 \ /VLAN10 SwitchA ==Tagged Trunk
== SwitchB VLAN20 / \VLAN20 The Trunk ...
Hi guys ... I didn´t post here in the last times, but know it´s again
time to do so. One of our customers uses a 110C (Running 4.0 MR1 Patch3)
with about 20 Ipsec connections to smaller offices. All are mainmode
connections to fixed ip sites, runni...
Hi guys, I´ve a problem with a bit " strange" setup. I need to have two
dialup connections with forticlient with fixed ip adresses within the
local network range. To get clearer: I´m using a FGT 110C thats
connected to two wan connections (one ADSL...
JasperW wrote:I upgraded my FGT201E saturday the 22nd from 6.2.4 to
6.2.5. The upgrade process went smooth. I do have problems with SSL Deep
Inspection, especially (strangely enough) on exempted addresses.In a
proxy-based policy with "ssl deep inspec...
"No matching IPsec selector, drop" is usually a problem with local and
remote networks in the ipsec phase 2.I dont know exactly how this is
configured in the FritzBox routers.You have to set up 0.0.0.0/0 as local
and remote in phase2 or create two ph...
Hi, I'm also from germany, and I know FritzBoxes ...Did you set up the
route to the other spokes lan to point at the ipsec tunnel in each
spoke?See: https://avm.de/service/fr...r-FRITZ-Box-zugreifen/
I'm using the volume weight method.As I understood, the weight entrys
are just proportions, so even 1000/1000/1/1 should do it ...I changed
now to 45/45/5/5 and will see what happens.